Water Based Car Paint Mixing Ratio

Base coat mixing is always a 50 50 mixture.

Water based car paint mixing ratio. A mixing ratio given as 4 2 1 normally means 4 parts of base product 2 parts thinner reducer and 1 part hardener. As a result only add hardener to the amount of paint that you anticipate using with the 8 hours. Solvent based metallic color should be thinned down at a ratio of two parts paint to one part standard basecoat thinners using a 2 1 scaled mixing stick. The water borne paint is also a base clear paint.

However some paint manufactures add hardener second and thinner reducer last. General information about water based paint. Although ratios vary widely across several products solvent based metallic paints are mixed in the ratio of 2 1 2 parts paint. When a mixing ratio is given as a percentage convert the percentage to a fraction then think of the fraction as parts solvent parts paint.

While the general guidelines are the same for most water based paints make sure that you check the manufacture s instructions for the paint that you are using prior to mixing. There is no need to add hardener to metallic basecoats. Mix this solution well and strain it before you pour it into the paint cup that s attached to the gun. Allow it to sit approximately 20 minutes before using.

The stick should rest upright against the walls of the pot. Once the mixture is stirred well pour it into a clean paint can and close the lid to keep the paint fresh. You have to thus refer to the instructions listed on the can before mixing the paint. The hardener will have a pot life of about 8 hours.

1 part thinner while water based paints are mixed with a 10 percent additive. Do not use tap or distilled water for this process. Once the amount of reducer is measured add it to the paint. Your paint never goes bad.

The ratio is 4 1 of paint to reducer. If you need to extend the life. 1 cup of base your paint color 1 cup reducer ready to paint. Step 2 take a clean mixing pot and place a paint mixing stick with the correct ratio markings inside it.

The mixing ratios are different for the two applications. Two stage painting ratio s. Stir the mixture of paint and reducer with a stir stick. Use the mixing pail to pour in the required amount of paint and reducer or primer and activator.

Add 1 2 pint of majic catalyst hardener to each gallon of paint 16 1.